<link rel="stylesheet" href="styles.f3b1fba60ec7970c.css">
Nasarawa State University, KeffiNasarawa State University, KeffiInstitutional Repository

DESIGN AND CONSTRUCTION OF AUTOMATIC WATER LEVEL CONTROLLER

Loading...
Thumbnail Image

Journal Title

Journal ISSN

Volume Title

Publisher

Physics Department, Nasarawa State University, Keffi

DOI

Abstract

The designed and construction of automatic water level controller was carried out using an arduino microcontroller for specific technological application. The design was achieved by first designing the power circuit consisting of rectifier diode, regulator IC,Zener diode, electrolytic capacitor and the ceramic capacitors which were connected in parallel using the arduino board, an ultrasonic module +5v supply were connected to the power supply circuit. The ultrasonic sensor and the LCD were als0 connected to the arduino. While the GND pins of both the arduino and the ultrasonic sensor were connected to the ground. The Vdd and VEE pins of LCD were connected to the potentiometer while VSS, RW and K- were connected to the ground. The last pin A+ was connected through a resistor and connected to +5V supply. A light emitting diode driver, buzzer and motor driver circuits were also connected to the arduino to the ground. Finally, an NPN transistor was connected to a 12V battery and then dc motor. Result shows that by connecting the device to a DC motor it be used as the pump to supply water to the overhead tank. The maximum level (tank height) was set at 300cm and low level is also set to be 12cm. As soon as the water level reached the tank height, the relay switches the pump off; this is to avoid wastage to stop water from overflowing the tank (wastage). Also test the ultrasonic sensor, water was drawn from the tank continuously until the low level or empty level was attained at which point the arduino automatically switched the pump on. Thus, the arduino successfully maintained water level between these limits as long as power is supply to the system. The LCD/ LED and the buzzer consistently display depending on the input base on the command code.

Description

Keywords

Citation

BEING A PROJECT SUBMITTED TO THE SCHOOL OF POSTGRADUATE STUDIES, NASARAWA STATE UNIVERSITY KEFFI, IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE AWARD OF DEGREE OF POSTGRADUATE DIPLOMA (PGD) IN PHYSICS (ELECTRONICS AND COMMUNICATION)

Endorsement

Review

Supplemented By

Referenced By